Konica Minolta PAGEPRO 9100 - Manual (Page 92)

Solving Problems 86
Printing
takes too
much time. The printer is set to a
slower printing mode
(Thick Stock or
Transparency media
types). It takes more time to print with special
media types, such as Transparencies.
When using regular paper, make sure
that the media type is set to Plain Paper
in the driver.
The printer is set to
energy-saving mode. It takes a little time for printing to start in
energy-saving mode. If you do not want
to use this mode, disable it.
The printer memory
is insufficient. Add more memory.
The job is very
complex.
Wait. No action needed.
The printer is set for
Single User Mode. If getting your jobs printed in a timely
manner is most important, use Network
Mode (Operator Control/Media Mode
menu).
You are
experiencing
problems
duplexing.
Media or settings are
not correct.
Make sure that you are using the correct
media. Do not duplex envelopes, glossy
stock heavier than 24 lb bond (90 g/m²),
labels, postcards, thick stock heavier
than 24 lb bond (90 g/m²), or
transparencies.
Make sure that your document has more
than one page.
In the printer driver (Properties/Layout/
Duplex Options), choose Short Edge
(flipped as on a clipboard) or Long Edge
(flipped as in a loose-leaf notebook).
Make sure that you are using correct
media.
The printing
is on the
wrong side of
the media. The printer is set to
autoduplexing and
you are trying to
duplex manually. If you are manually duplexing, in the
printer driver (Properties/Layout) choose
Simplex.
The media is not
installed correctly. Load the media printing-side up.
Symptom Cause Solution