Konica Minolta PAGEPRO 9100 - Manual (Page 126)

Internal IDE Hard Disk Drive 120
2
Remove the controller board.
Loosen four screws, and pull
the controller board
from the printer.
3
Position the controller board
on a flat surface so it lies flat
and the I/O connector panel
is facing you.
4
Attach the internal IDE hard
disk drive to the hard disk
bracket.
Attach the internal IDE hard
disk drive to the bracket with
the grooved-end of the bracket
facing the ribbon cable. The
screw holes in the bottom of
the hard disk should match up
with the holes on the hard disk
bracket. Fasten the hard disk
to the bracket with the screws
provided.
5
Position the hard disk so that the four support posts face the controller
board, the colored stripe on the ribbon cable faces away from you, and
the connector is down.
6
Insert ribbon cable connector pin 1 (the colored stripe side of the cable) in
hard disk connector pin 1.
Attention
Make sure that the ribbon cable connector and the controller board
connector pins are properly aligned. Damage to the controller board
could result if the pins are misaligned.
7
Press down gently but firmly on the cable connector until it is fully seated.
Attention
Do not push or pull with the ribbon cable. Use the cable connector.
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII