HID DTC400E/C30E/M30E User Guide - Manual (Page 31)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 3-5
Installing the Print Ribbon Cartridge
The DTC400e/C30e/M30e Card Printer uses a one-piece, disposable Ribbon Cartridge load
system.
Step Procedure
1 To install the Ribbon Cartridge, simply open the front Cover by pressing the
black rubber pad or touch pad and lowering the Cover down, as shown below.
2 a. Remove the liner on the Card Cleaning Roller before installing the Cartridge,
as shown in Display A (upper right arrow of display).
b. Remove the Ribbon securing tape, as shown in Display A (middle right arrow
of display).
3 Slide the Ribbon Cartridge into the Printer, as shown in this section.
4 Raise the front Cover and press the front Cover’s black rubber pad or touch pad
to secure it.
Display A – Shows the Print Ribbon Cartridge before it is installed or inserted into the Printer.
The Card Cleaning Roller (see arrow) is already inserted into the Print Ribbon Cartridge.