HID DTC400E/C30E/M30E User Guide - Manual (Page 260)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 8-5
2 Remove all the cards from the Printer’s Input Hopper.
3 Use the Cleaning Card from the Printer’s Cleaning Kit and remove the
adhesive backing from both sides of the card. (Note: If your Printer has a
Magnetic Encoder installed, be sure to leave the small Liner Strip on top of the
Cleaning Card in place. This small strip is needed to protect the Magnetic
Head from the adhesives on the Cleaning Card.)
4 Insert the Cleaning Card into the Single Feed Card Slot until the card stops.
(Note: If your Printer is equipped with a Magnetic Encoder, you must insert the
Cleaning Card with the printed side up and with the small Liner Strip towards
the front of the Printer.)