HID DTC400E/C30E/M30E User Guide - Manual (Page 223)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 6-99
Using the Print Top of Form Option
Use this option to adjust the lengthwise or horizontal position of the printed image on a card
so it appears centered. (Note: When adjusting this value, keep in mind that cards always
remain in the same landscape orientation while moving through the Printer.)
The diagram (below) represents how the printed image will move in relation to the fixed card
position as a positive or negative Image Placement value is entered.
Step Procedure
1 Enter a negative value to move the printed image toward the leading edge of
the card or the card output to the side of the Printer.
OR
Enter a positive value to move the printed image toward the trailing edge of the
card or the card input to the side of the Printer.
• Maximum Adjustment Range: The maximum adjustment range is ±127.
As a rule, 20 equals about .030"/. 8mm, which is about the same as the
thickness of a standard CR-80 size card.
Caution: If the negative value is set too high, the print Ribbon may
break.