HID DTC400E/C30E/M30E User Guide - Manual (Page 250)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e/Persona C30e/M30e Card Printer User Guide (Rev. 1.1) 7-12
Selecting the NONE- Re-Writable Ribbon Type
DTC400e/C30e
Follow these instructions:
Caution: No Ribbon is used with these cards. Do not load a Ribbon into the printer when
using this process. Printing on the Re-Writable card with a Ribbon will ruin the card.
• The default setup is for the printer to first erase the previously-printed card; then write the
NEW information on the card. (Note: If you are printing to a NEW card, select WRITE
ONLY. This will speed up the process. The FULL card is erased and printed; there is no
option to select specific areas to erase.)
• To print/erase a certain section use the “Overlay/Print Area” tab in the driver. Select the
specific area in the same manner as the print job with the color ribbon.
• To erase many cards, use the Fargo Workbench Re-Writable Card Eraser option. (Note:
This option does not print only erase.)