Allied Telesis SwitchBlade x3112 - Manual (Page 91)

SwitchBlade x3112 Installation Guide
91
3. Insert one end of the grounding wire into the grounding lug, as shown
in Figure 45, and use a crimping tool to secure the wire to the
grounding lug.
Figure 45. Attaching the Grounding Wire to the Grounding Lug
4. Install the grounding lug on the chassis, as shown in Figure 46. Allied
Telesis recommends tightening the screws to 20 inch-lbs.
Figure 46. Installing the Grounding Lug and Wire
5. Connect the other end of the grounding wire to the building protective
earth.
6. Go to Chapter 4, “Installing the Power Supplies” on page 93.