Allied Telesis SwitchBlade x3112 - Manual (Page 61)

SwitchBlade x3112 Installation Guide
61
The following SD flash memory cards are officially supported in this
release.
 SanDisk 2GB Flash card
 SanDisk 4GB SDHC Flash card
Note
Other brands can be used but are not guaranteed to work.
For ordering information, contact your Allied Telesis sales representative
or visit our web site.
SD Status LED
The SD Status LED on the AT-SBx31CFC Central Fabric Controller card is
described in Table 16.
Caution
To avoid losing data, do not remove an SD card when the SD status
LED is flashing green. Use the DEACTIVATE MEDIA command in
the SwitchBlade x3112 Management Software to disable the SD
card slot and wait for the SD status LED to turn off before removing
an SD card.
USB Port The USB port is not supported at this time.
Table 16. SD Status LED
LEDs State Description
SD
Off The SD slot is empty, the SD card is
improperly installed, or the SD slot was
deactivated in the SwitchBlade x3112
Management Software.
Solid Green The SD card is properly installed in the
slot and ready to transfer data.
Flashing Green The AT-SBx31CFC Central Fabric
Controller card is retrieving or storing data
on the SD card.
Flashing Amber The control card is detecting a problem
with the SD card. The card may be
installed improperly in the slot or there
may be a problem with the card itself.