Allied Telesis SwitchBlade x3112 - Manual (Page 157)

SwitchBlade x3112 Installation Guide
157
Figure 110. Securing the Power Cord for the AT-SBxPWRSYS1 Power
Supply to an Anchor
4. Connect the power cord to an appropriate AC power source to power
on the power supply.
5. If the chassis has two AT-SBxPWRSYS1 System Power Supplies,
repeat steps 1 to 4 to power on the second power supply.
After powering on the AT-SBxPWRSYS1 System Power Supplies, do one
of the follow:
 If the chassis has AT-SBxPWRPOE1 PoE Power Supplies,
perform the procedure in “Powering on the AT-SBxPWRPOE1 AC
Power Supply” on page 158.
 Otherwise, go to “Monitoring the Initialization Process” on
page 184.
Anchor