beautypg.com

Figure 94: attaching a fiber optic cable – Allied Telesis SwitchBlade x3112 User Manual

Page 139

background image

SwitchBlade x3112 Installation Guide

139

6. Connect the fiber optic cables to the port on the transceiver, as shown

in Figure 94. The connectors should snap into the ports. If you are
connecting only one cable to a CSFP transceiver, you may connect it
to either port.

Figure 94. Attaching a Fiber Optic Cable

7. Repeat this procedure to install additional SFP and CSFP

transceivers.

After installing and cabling the SFP and CSFP transceivers, do one of the
following:

To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.

After cabling all the ports in the chassis, go to Chapter 7,
“Powering On the Chassis” on page 153.

SFP Transceiver

CSFP Transceiver