Allied Telesis SwitchBlade x3112 - Manual (Page 87)

SwitchBlade x3112 Installation Guide
87
2. Lift the AT-SBx3112 Chassis into the equipment rack and set the
bottom of the equipment rack brackets firmly on the two equipment
rack screws you installed in “Preparing the Equipment Rack” on
page 79.
Figure 40. Lifting the AT-SBx3112 Chassis into the Equipment Rack
3. With the bottom of the rack mount ears resting on the two rack mount
screws, tilt the top of the chassis back until both rackmount brackets
are flush and parallel with the vertical rack rails.
4. Install six rack mount screws (not provided) to secure the chassis to
the equipment rack, as shown in Figure 41 on page 88.