Adding a new calibration, New calibrations, see, Adding a new – Ag Leader InSight Cotton Harvest Insert Ver.6.0 Users Manual User Manual
Page 33

InSight™ Firmware Version 6.0
605
PN: 2002881 Rev.F
A
DDING
A
N
EW
C
ALIBRATION
After installing the system, you must calibrate the monitor for cotton weight before it will provide
accurate results. Each time you calibrate the monitor, it will automatically correct cotton yield data for all
regions associated with the active calibration. Performing a new calibration at the beginning of each
subsequent harvest season is not necessary, but is recommended. As you harvest, you may notice changes
in yield accuracy because of changes in field conditions or the variety being harvested. If you detect this
type of change, you can perform a new calibration using the following procedure.
Once you create a new calibration, there is no need to create additional crops
along with this new calibration, as the Retire Calibration and Move Region functionality eliminate any need
to create multiple cotton crops. The new calibration will be applied to the original cotton crop.
Step 1: Show Calibration Numbers
On the Harvest window, under the Calibration
tab, press the Show Calibration button. The
Weight Calibration window appears, as shown
at left.
Step 2: Start New Calibration
On the Weight Calibration Window, press the
New Cal button.