Ag Leader InSight Cotton Harvest Insert Ver.6.0 Users Manual - Manual (Page 18)

InSight™ User Guide - Cotton Harvest Insert
590
PN: 2002881 Rev.F
C
ALIBRATE
D
ISTANCE
The following procedure describes a speed sensor calibration. Before beginning, keep in mind these two
tips:
• Before beginning the speed sensor calibration, you should mark a measured distance to drive. The
default distance currently in the InSight monitor (and the recommended distance) is 100 feet, or 50
meters if using metric measurements.
• For the most accurate results, this calibration should be performed in field conditions (not on gravel or
paved roads)
To begin, first select a Picker from the list and press the Calibrate Distance button to calibrate the radar,
track or wheel speed sensor.
Step 1: Select Speed Input
Select the sensor type to calibrate and press
NEXT to continue.
Step 2: Calibration Distance
The system defaults to 100 feet (or, if using
metric, 50 meters) distance for calibration.
Press Edit Distance to change if needed. This
value must match the actual distance of the
course driven for calibration.
Press NEXT to continue.
Step 3: Start Driving Course
Follow the on-screen directions and press START
to begin the calibration process.