HP e-CommerceXML Accelerator sa7150 - Manual (Page 69)

C H A P T E R 4 Scenario 2—Single Server Configuration
59
Scenario 2—Single Server Configuration
NOTE: This
configuration is intended
primarily for use with
SSL-intensive
operations—it is not
optimal for XML
environments. This scenario describes a typical configuration of a SA7150 with one
server, using either automapping or manual configuration/mapping.
This scenario describes the fastest way to get up and running with a
SA7150.
Single SA7150, Single Server Installation
Procedure for
Scenario 2 Automapping
1. Physically connect the SA7150 to the router and to one server.
NOTE: XML is by
default disabled for each
map. You must
specifically enable a map
to process XML requests.
See set xml command in
Chapter 5. 2. Initiate HTTPS traffic to the server. The SA7150 monitors traffic
and uses the initial mapping (with associated default key and
certificate) to decrypt HTTPS traffic and pass clear text HTTP
traffic to the server.
Manual Configuration
1. Perform the installation as described in Chapter 2. Access the
SA7150 command prompt.
2. Acquire the appropriate keys and certificates following the
procedure in the “Keys and Certificates” section in Chapter 3.
Single Server
Router
HP e-Commerce/XML Server Accelerator SA7150