HP e-CommerceXML Accelerator sa7150 - Manual (Page 129)

C H A P T E R 6 Remote SSH Sessions
119
Remote SSH Sessions
NOTE: The default user
name and password for
SSH sessions are admin. This section contains procedures for accessing the SA7150’s CLI via
remote Secure Shell (SSH) session. The table below illustrates
ciphers supported by the domestically available SA7150 under SSH1
and SSH2. The export version of the product supports only the SSH2
cipher DES.
Supported Ciphers
Local Serial
Console Assign an IP address to the SA7150’s network interface using the
following procedure:
HP SA7150> set ip
Enter IP Address (’none’ to delete)
[10.1.2.65]: 10.1.1.1
Enter Netmask (’none’ to delete)
[255.255.255.0]: 255.255.255.0
Verify the IP and netmask (optional):
HP SA7150> show ip
System IP Address: 10.1.1.1
System Netmask: 255.255.255.0
Enable remote SSH sessions:
HP SA7150> set ssh enable
Configure the network route:
HP SA7150> set route
Enter Default Route (’none’ to delete)
[10.1.1.1] :
Verify the route configuration (optional):
HP SA7150> show route
Default Route : 10.1.1.1
SSH1 SSH2
Cipher 3DES, DES, Blowfish 3DES, Twofish, RC4,
“None”
MAC MD5, “None”