HP e-CommerceXML Accelerator sa7150 - Manual (Page 20)

C H A P T E R 2 HP e-Commerce/XML Server Accelerator SA7150 User Guide
10
Free-Standing
Installation 1. Attach the provided self-adhesive rubber feet to the SA7150’s
bottom.
2. Place the SA7150 on a flat surface and make sure that there is
adequate airflow surrounding the unit (allow at least one inch of
air space on all sides).
Network
Connections 1. Use the table below to select and install the appropriate network
cables (Category 5 UTP or better):
NOTE: Never connect
both of the SA7150’s
network ports to the same
switch, hub, or router.
Doing so creates a
feedback loop that
adversely effects network
bandwidth. 2. Connect the provided power cable to the back of the unit. (There
is no power switch.) Under normal circumstances, the SA7150
requires approximately 30 seconds to boot. When the boot is
complete, the unit’s Power LED is steadily illuminated. (If the
Power LED is not steadily illuminated, see Chapter 9,
“Troubleshooting,” to rectify before proceeding to Step 3.
)
3. The Inline LED should be either steadily illuminated or blinking
(to indicate Inline mode). If it is not, press the Bypass switch on
the device’s front panel to enable Inline mode.
SA7150’s network
connector SA7150’s server
connector
Workstation or Server Crossover cable Straight-through cable
Switch or Hub Straight-through cable Crossover cable
Router Crossover cable Not recommended
SA7150 network
connector* N/A Straight-through cable
SA7150 server
connector* Straight-through cable N/A
* Applicable only to multiple, cascaded units