HP e-CommerceXML Accelerator sa7150 - Manual (Page 105)

C H A P T E R 5 Command Reference
95
set telnet Enables or disables Telnet sessions. When this command is set to
“enable” and an IP address is assigned to the SA7150’s network
interface, you can access the device’s CLI via remote Telnet
session. When disabled, the device refuses Telnet connections. The
console prompts for any missing parameters. Default: disable.
Syntax:
HP SA7150> set telnet enable
Need an IP address to start Telnet service.
Enter IP Address
[209.218.240.67]:10.1.2.124
Need a netmask to start Telnet service.
Enter Netmask [255.255.255.0]:
Optional Default Route to start Telnet
service.
Enter Default Route (’none’ to delete)
[none]:
Telnet Services started.
HP SA7150>
show telnet Displays current Telnet status: enabled or disabled.
Example:
HP SA7150> show telnet
Telnet: enabled
set telnet_port Set the port on which Telnet connections are accepted. (Default
port: 23.)
Syntax:
HP SA7150> set telnet_port
where is the number of the port to which Telnet sessions
will connect.
show telnet_port Display the port on which Telnet sessions are currently accepted.
Example:
HP SA7150> show telnet_port
Telnet port: 23
Command Description