HP e-CommerceXML Accelerator sa7150 - Manual (Page 21)

C H A P T E R 2 Physical Installation
11
4. At this point both the Network and Server LEDs should be
steadily illuminated. If not, please see Chapter 9,
“Troubleshooting.”
Wiring Connections
Console
Connection Run HyperTerminal* or a similar terminal emulator on your PC. The
steps below assume HyperTerminal* is used. Other terminals will
require different procedures.
1. Use the serial cable provided with the SA7150 to connect the
device’s serial port (the left-hand serial port labeled “Console”)
to the serial port of any terminal.
Front Panel Connectors and LEDs
2. Type an appropriate name in the Name field of the Connection
Description window (e.g., “Configuration”), and then click the
OK button. The Phone Number panel appears.
3. In the Connect Using… field specify “COM1” (or the serial port
through which the PC is connected to the SA7150 if different
from COM1).
XML Server 1
XML Server 2
Default Server
hub/switch
HP e-Commerce/XML Server
Accelerator SA7150
hub/switch
Bypass
Reset
Network Link
(RJ45)
Server Link
(RJ45)
Inline
(green)
Network
(green)
Server
(green)
LEDs
Fail-through switch
Console
(CLI)
Aux Console
(Diagnostics)
Power
(green)
Error
(red)
Overload
(amber)
Activity
(green)
LEDs