Set ntp poll, Set ntp primary – HP Onboard Administrator User Manual
Page 98
Enclosure network configuration commands 98
SET LOGIN_BANNER_TEXT
•
Description:
Sets the login banner text to be displayed when the user attempts to log in to the Onboard
Administrator.
To enter the login banner text:
a.
Start with a string that does not appear within the certificate (the end marker).
b.
Insert a newline character by pressing Enter.
c.
Paste in the certificate.
d.
Insert a newline character by pressing Enter.
e.
Insert the end marker.
f.
Issue the command by pressing Enter.
Failure to give a proper end marker before and after the banner text might cause the interface to wait
for the appropriate end marker indefinitely.
•
Access level /Bay level:
OA administrator
•
Restrictions:
o
This command is only available in script mode.
o
The end marker must not consist of all numeric characters (for example, 1245, 85213, and so on).
o
The minimum length of the banner text must be 1 character and the banner text cannot exceed 1500
characters.
o
The command accepts English (ASCII) characters only.
o
The characters ‘%’ and ‘\’ are not permitted as part of the banner text itself, but you can use them
as characters in the end marker to make a unique string.
o
The banner text must contain at least one visible character.
SET NTP POLL
•
Command:
SET NTP POLL
•
Description:
Sets the polling interval of the NTP servers
•
Access level/Bay level:
OA administrator, OA operator
•
Restrictions:
Poll time should be between 60 and 86,400 seconds.
SET NTP PRIMARY
•
Command:
SET NTP PRIMARY