HP Onboard Administrator - Manual (Page 138)

Enclosure management commands 138
ICBAY | HP 4Gb Fibre Channel Pass-thru Module for c-C | 6A | 2.4.3 |
2.10.3
ICBAY | HP 4Gb Fibre Channel Pass-thru Module for c-C | 7A | 2.4.3 |
2.10.3
ICBAY | HP 4Gb Fibre Channel Pass-thru Module for c-C | 8A | 2.4.3 |
2.10.3
BLD | BladeSystem Location Device | - |1.10
| 1.10
Update 1Gb Ethernet PT module 1A via command UPDATE device ICBAY 1A
Update 4Gb Fibre Channel PT module 8A via command: UPDATE device ICBAY 8A
UPDATE ILO
• Command:
UPDATE ILO {ALL | [{ , | - } ]} [TPM_FORCE]
• Description:
o The UPDATE ILO command downloads a new flash image from the network and uses it to update
the firmware for iLO.
o Supported protocols are HTTP, HTTPS, TFTP, and FTP.
o The URL must be formatted as protocol://host/path/filename.
o If your FTP server does not support anonymous logins, then a username and password can be
specified within the URL that is formatted as: ftp://username/password@host/path/filename.
o If TPM is installed and enabled on the server blade, the UPDATE ILO command must include the
TPM_force option after the URL.
o Upgrading an iLO without performing the proper OS encryption procedure will result in loss of
access to your server data if a TPM is enabled. If you do not have your recovery key or have not
suspended encryption, do not flash iLO.
• Access level/Bay level:
Administrator
Blade bay
• Restrictions:
o If maximum users exist in iLO (12), then this command fails. A user account must be available to
execute this command.
o This command is not applicable to HP Integrity server blades.
UPDATE IMAGE FW_ISO
• Command:
UPDATE IMAGE {[FORCE] FW_ISO | SYNC}
• Description:
o The IMAGE command downloads a new flash image from the network and uses it to update the
Onboard Administrator firmware. If a redundant Onboard Administrator is present in the system,
then this command flashes and validates its firmware before attempting to flash the active Onboard
Administrator.