HP Onboard Administrator - Manual (Page 56)

General management commands 56
SET URB PROXY URL { } sets the proxy URL to use when sending URB messages.
SET URB INTERVAL { HOURLY | DAILY | WEEKLY |
MONTHLY } sets the interval at which URB messages are sent.
• Access level/Bay level:
OA Administrator, OA Operator
• Restrictions:
SET URB URL { }: The URL must be either an HTTP or HTTPS URL and can be no longer than
128 characters.
SET URB PROXY URL { }: The URL can be no longer than 128 characters.
SET URB INTERVAL { HOURLY | DAILY | WEEKLY |
MONTHLY }:
o The minutes parameter must be 0-59.
o The DAILY hour parameter must be 0-23.
o The WEEKLY day parameter must be 1-7 where 1 is Sunday and 7 is Saturday.
o The MONTHLY day parameter must be 1-31.
SHOW ALL
• Command:
SHOW ALL
• Description:
Executes all SHOW commands in succession
• Access level/Bay level:
All
• Restrictions:
o This command only displays the bays for which you have privileges.
o To save the output, you must configure your Telnet software to log the session to a file or increase the
history buffer size so that the output can be copied and pasted into another file.
o The SHOW ALL command is a series of individual CLI commands, as shown in the example that
follows. For specific command output examples, see the individual commands in this guide.
• Example:
C3000-OA2> show all
>SHOW HEALTH
>SHOW CONFIG
>SHOW DATE
>SHOW DISPLAY EVENT
>SHOW EBIPA
>SHOW EBIPAV6
>SHOW ENCLOSURE FAN ALL
>SHOW ENCLOSURE INFO
>SHOW ENCLOSURE LCD
>SHOW ENCLOSURE POWER_CAP
>SHOW ENCLOSURE POWER_CAP_BAYS_TO_EXCLUDE
>SHOW ENCLOSURE POWERSUPPLY ALL