HP Onboard Administrator - Manual (Page 161)

Blade management commands 161
Displays the port mapping for the server specified by the bay number
• Access level/Bay level:
All
Bay specific
• Restrictions:
o You must have access to the specified bay number.
o This command is not applicable to storage blades.
o Different sides of the server bay cannot be designated within the same range.
• Example:
OA-0018FE27577F> SHOW SERVER PORT MAP ALL
Mezz
Mezz Mezz Device Port Interconnect Interconnect
Slot Device Port Status Bay Bay Port Device ID
---- ------ ------ ---------- ------------ ------------ ----------------
------------------------------- Blade 001 -------------------------------
1 Not Present
2 Not Present
3 Not Present
Embedded Ethernet
Port 1 OK Bay 1 Port 5 00:19:BB:24:51:0C
iSCSI 1 OK Bay 1 Port 5 00:19:BB:24:51:0D
Port 2 OK Bay 1 Port 13 00:19:BB:24:51:24
iSCSI 2 OK Bay 1 Port 13 00:19:BB:24:51:25
Port 3 OK Bay 1 Port 1 00:19:BB:21:ED:EF
Port 4 OK Bay 1 Port 9 00:19:BB:21:ED:F0
------------------------------- Blade 002 -------------------------------
1 Not Present
2 Not Present
3 Not Present
Embedded Ethernet
Port 1 OK Bay 1 Port 6 00:19:BB:34:A1:5A
iSCSI 1 OK Bay 1 Port 6 00:19:BB:34:A1:5B
Port 2 OK Bay 1 Port 14 00:19:BB:34:91:FE
iSCSI 2 OK Bay 1 Port 14 00:19:BB:34:91:FF
Port 3 OK Bay 1 Port 2 00:19:BB:29:91:33
Port 4 OK Bay 1 Port 10 00:19:BB:29:91:34
------------------------------- Blade 003 -------------------------------
------------------------------- Blade 004 -------------------------------
1 Not Present
2 Not Present
Embedded Ethernet
Port 1 OK Bay 1 Port 4 00:16:35:C5:EF:26
iSCSI 1 OK Bay 1 Port 4 00:16:35:C5:EF:27
Port 2 OK Bay 1 Port 12 00:16:35:C5:EF:3A
iSCSI 2 OK Bay 1 Port 12 00:16:35:C5:EF:3B
------------------------------- Blade 005 -------------------------------