HP Onboard Administrator - Manual (Page 192)

VLAN commands 192
SET VLAN OA
• Command:
SET VLAN OA
• Description:
Sets or changes the VLAN ID of the Onboard Administrator. Loss of connectivity to the Onboard
Administrator will occur if this is improperly set.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
SET VLAN REVERT
• Command:
SET VLAN REVERT
• Description:
Reverts VLAN settings back to saved FLASH configuration data in seconds. Use a delay of 0
to cancel the command. Any newly issued revert command takes precedence over an outstanding one.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
SET VLAN SERVER
• Command:
SET VLAN SERVER { ALL | [{ , | - } ] }
• Description:
Sets the VLAN ID for the specified server or range of servers.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o You must create a VLAN ID using the ADD VLAN command, before using the SET VLAN SERVER
command, or the command is rejected.
o All multi-blade servers must be on the same VLAN.
SHOW VLAN
• Command: