HP Onboard Administrator - Manual (Page 62)

Enclosure Bay IP Addressing commands 62
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
Before using this command, you must set up the EBIPA IPv6 settings. This includes setting the initial IP
address.
REMOVE EBIPA
• Command:
REMOVE EBIPA {SERVER|INTERCONNECT} DNS [{ , | - } ]
• Description:
Removes the DNS server specified by the from the list of DNS servers for either SERVER
bays or INTERCONNECT bays
• Access level/Bay level:
Administrator, Operator
• Restrictions:
The and must be in the form ###.###.###.###, where each ### ranges from 0 to 255.
REMOVE EBIPAV6
• Command:
REMOVE EBIPAV6 { SERVER | INTERCONNECT } DNS [ ALL |
number> [{ , | - } ] ]
• Description:
Removes an EBIPA DNS server IPv6 address from the list of DNS servers for either server bays or
interconnect bays.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
o A bay number or bay range may be specified. If no bay number or bay range is specified, the IPv6
DNS server is removed from all servers or interconnects.
o The must be in the form ####:####:####:####:####:####:####:####/###,
where #### ranges from 0 to FFFF. A compressed version of the same IPv6 address is also
supported.
SAVE EBIPA
• Command:
SAVE EBIPA
• Description:
Saves EBIPA settings for server bays or interconnect bays.