HP Onboard Administrator - Manual (Page 112)

Enclosure management commands 112
• Description:
Connects to the OA CLI on a linked enclosure. To get a list of linked enclosure names, use the SHOW
TOPOLOGY command.
• Access level/Bay level:
All
• Restriction:
None
DISABLE DHCP_DOMAIN_NAME
• Command:
DISABLE DHCP_DOMAIN_NAME [ | ACTIVE | STANDBY]
• Description:
o Disables the DHCP domain name, allowing the user to enter a domain name instead of the one
supplied by DHCP. For more information, see the SET OA DOMAIN_NAME (on page
118 )
command.
o This command requires that Dynamic DNS is enabled. If bay number is not specified, the command
will default to the OA where the command is being run.
o If the user has previously disabled the DHCP-supplied domain name, this command will cause the
specified OA to revert to using the DHCP domain name.
o If Dynamic DNS is enabled, then ENABLE will succeed, otherwise the ENABLE command will fail
with an error message: Dynamic DNS is not enabled.
• Access level/Bay level:
OA administrator, OA operator
• Restrictions:
None
DISABLE GUI_LOGIN_DETAIL
• Command:
DISABLE GUI_LOGIN_DETAIL
• Description:
Disables extended enclosure information available in the GUI on the login page
• Access level/Bay level:
OA administrator, OA operator
• Restriction:
None
DISABLE LLF
• Command: