Set server boot first, Set server boot once – HP Onboard Administrator User Manual
Page 155
Blade management commands 155
o
) sets the boot device to be used on the next boot of the
bays specified.
•
Access level/Bay level:
OA administrator, OA operator
Bay specific
•
Restrictions:
o
You must have access to the specified bay number.
o
This command is not applicable to storage blades.
o
This command is not applicable to HP Integrity server blades.
o
The RBSU and NORMAL options are only available for SET SERVER BOOT ONCE.
o
The USB option is only available for SET SERVER BOOT FIRST.
o
This setting is only valid on present blades and cleared if the blade is removed.
o
This version of Onboard Administrator firmware does not support boot options for servers
configured in UEFI boot mode.
SET SERVER BOOT FIRST
•
Command:
SET SERVER BOOT FIRST {HDD | FLOPPY | PXE | CD} {ALL |
, }
•
Description:
o
Stores a setting for the IPL to be passed to the specified servers at the next reboot.
o
HDD sets the boot order of the blade to Hard Disk Drive, PXE.
o
PXE sets the boot order of the blade to PXE, Hard Disk Drive.
o
Sets the boot device to be used on the next boot of the bays specified.
•
Access level/Bay level:
OA administrator, OA operator
Bay specific
•
Restrictions:
o
You must have access to the specified bay number.
o
This command is not applicable to storage blades.
o
This command is not applicable to HP Integrity server blades.
o
This setting is valid only on present blades and is cleared if the blade is removed.
o
This version of Onboard Administrator firmware does not support boot options for servers
configured in UEFI boot mode.
SET SERVER BOOT ONCE
•
Command: number> [{ - | , }
SET SERVER BOOT ONCE {NORMAL | HDD | FLOPPY | PXE | RBSU | CD} {ALL |