HP Onboard Administrator - Manual (Page 131)

Enclosure management commands 131
SHOW OA INFO [ALL | [{ , | - } ] | ACTIVE | STANDBY]]
• Description:
Displays information about the Onboard Administrator. If the Onboard Administrator is not specified,
the command defaults to the Active Onboard Administrator.
• Access level/Bay level:
All
• Restrictions:
None
• Example:
OA-0018FE27577F> SHOW OA INFO
Onboard Administrator #1 information:
Product Name : BladeSystem c3000 Onboard Administrator
Part Number : 123456-B21
Spare Part No.: 123456-001
Serial Number : PLO590A9FDJ8
UUID : 123P4R5T6YVUQ04B
Manufacturer : HP
Firmware Ver. : 2.20
Hw Version : A0
Loader Version: U-Boot 1.2.1 (Dec 7 2012 - 13:27:25)
Serial Port:
Baud Rate : 9600
Parity : None
Data bits : 8
Stop bits : 1
Flow control: None
SHOW OA NETWORK
• Command:
SHOW OA NETWORK [ALL | [{ , | - } ] | ACTIVE | STANDBY]]
• Description:
Displays the network configuration for the specified Onboard Administrator. If you do not specify the
Onboard Administrator (ACTIVE or STANDBY), the command defaults to the active Onboard
Administrator. If the domain name is set, it is displayed in the output under the “- - - - - IPv4 Information
- - - - -“ heading.
• Access level/Bay level:
OA administrator, OA operator, OA user
• Restrictions:
VLAN ID information appears only when VLAN is enabled.
• Example:
OA-E4115BECFBAB> show oa network
show oa network
Enclosure Network Settings:
- - - - - IPv6 Information - - - - -
IPv6: Enabled