HP Latex 3000 Printer User Manual
Latex 3000 printer
Table of contents
Document Outline
- Introduction
- HP Internal Print Server
- Start the Internal Print Server
- Change the language of the Internal Print Server
- Change the units of measurement in the Internal Print Server
- Set the Internal Print Server preferences
- Internal Print Server menus
- Printer status and alerts
- Update the firmware and the Internal Print Server
- Maintain the Internal Print Server
- Handle the substrate
- Supported substrate types
- Supported HP substrates
- Substrate tips
- Substrate configurations
- Prepare to print
- The substrate edge holders
- The ink collector kit
- Load a roll onto the spindle
- Load a roll into the printer
- Double-sided printing
- View information about the loaded substrate
- Unload a roll
- Substrate presets
- Use a new substrate
- Prepare the printer for a new substrate
- Create a new substrate preset with the Add New Substrate wizard
- Edit a substrate preset
- Remove a substrate preset
- Set the carriage beam position
- Create and manage print jobs
- Handle the ink system
- Printer calibration
- Align the printheads
- Possible difficulties with printhead alignment
- Color calibration
- Color consistency between different HP Latex 3000 printers
- Color profiles
- Substrate-advance compensation
- Calibrations specific to one substrate preset
- Recommended calibrations after particular events
- HP Print Care
- Hardware maintenance
- Safety precautions
- Maintenance resources
- How to perform maintenance operations
- How to turn the printer off and on for maintenance operations
- Summary of maintenance operations
- Daily maintenance
- Clean the print zone
- Clean the bottom of the carriage, the drying glasses, and the line sensor
- Clean the pinchwheels and drive roller
- Clean the ink deposits
- Clean the carriage rails and replace the oiler foams
- Empty the oil collector caps
- Replace the e-cabinet fan filters
- Replace the rubber blade
- Clean the perforated plate
- Replace the drying lamps
- Grease the carriage beam screws
- Clean the rear scan-axis beam
- Clean the substrate-advance sensor
- Replace a pinchwheel submodule
- Replace a primer
- Replace the aerosol fan module
- Replace the drying fans array
- Replace the drying quartz glass
- Replace a curing fan and resistor module
- Replace a service station cap
- Replace an intermediate tank
- Replace an e-cabinet fuse
- Clean the printhead contacts
- Replace a spindle valve
- Clean the roll-to-free-fall roller and pinchwheels
- Clean the carriage rails manually
- Clean the aerosol filters
- Wipe the top of the protector
- Wipe the ribs of the ink collector modules
- Wipe the protector
- Wipe the ink collector modules
- Printer maintenance
- Replace the ink collector foams
- Troubleshoot substrate issues
- Loading issues
- Printing issues
- A spindle latch suddenly opens during printer operation
- The substrate advances with a loud continuous sound of vibration
- There is skew or telescoping on the output spindle
- There are wrinkles and ink smears on the substrate
- There are ink marks on the substrate
- The substrate sticks to the platen
- There are physical marks on the substrate
- There are drops of ink on the substrate
- Print length issues
- Collector issues
- Troubleshoot print-quality issues
- General advice
- Basic and advanced troubleshooting
- Advanced print-quality troubleshooting
- Troubleshoot ink cartridge and printhead issues
- Troubleshoot other issues
- When you need help
- Printer specifications
- Printer messages
- Glossary
- Index