HP Latex 3000 Printer User Manual
Page 57
19.
Go to the Internal Print Server and press the Finish button. The printer rotates both rolls to check their
diameters, and it also checks the width of the roll, the winding direction, the vacuum, and the substrate
advance calibration (this takes about a minute).
NOTE:
The roll size appears at the bottom of the screen; to change it, click Change substrate
settings.
NOTE:
Some substrates (such as transparent substrates) cannot be measured by the printer in this
way. In such cases, you will be asked to enter the Left Edge and Width fields yourself into the Internal
Print Server. Use the ruler on the spindle to check these values.
20.
An alert about substrate-advance tracking may appear at this point. For more information on when you
might want to turn off automatic tracking, see
Substrate-advance compensation on page 128
.
21.
For more information on when you might want to change the carriage beam position, see
Manual loading
1.
Use the Internal Print Server to raise the carriage beam to its loading position.
2.
Open the front door.
ENWW
Load a roll into the printer
51