HP Latex 3000 Printer - Manual (Page 13)

Warning labels
Label Explanation
Located on the e-cabinet; for service personnel only
Electric shock hazard
Heating modules operate at hazardous voltage. Disconnect
power source before servicing.
Caution! Double pole. Neutral fusing. Refer servicing to qualified
service personnel.
In case of operation of the fuse, parts of the printer that remain
energized may represent a hazard during servicing. Before
servicing, turn off the printer using the Branch Circuit Breakers
located in the building's Power Distribution Unit (PDU).
Warning
High leakage current. Current leakage may exceed 3.5 mA. Earth
connection essential before connecting supply. Equipment to be
connected to earthed mains only.
See installation instructions before connecting to the supply.
Ensure that the input voltage is within the printer's rated voltage
range. The printer requires up to two dedicated lines, each
protected by a branch circuit breaker according to site
preparation requirements.
Before starting
Read and follow the operating and safety instructions before
starting the printer.
Located on the curing and drying modules
Risk of burns. Do not touch the internal enclosures of the printer's
drying and curing modules.
Located on each side of the substrate path, close to the PPS gear
Crush hazard. Do not touch PPS while moving. When the
substrate has been loaded, the carriage descends into its printing
position, and could crush your hand or anything else left
underneath it.
Located on each side of the substrate path, close to the PPS gear
Risk of trapped fingers. Do not touch gears while moving. Danger
that your hands may become trapped between gearwheels.
ENWW Safety precautions 7