HP 3PAR Operating System Software - Manual (Page 352)

3PAR InForm Management Console 4.1.0 User’s Guide
352 320-200231 Rev A
The upper pane of the RCFC tab displays summary information about the system's RCFC
ports. The lower pane displays details about a selected RCFC port from the upper pane.
The following information is displayed in the upper pane:
Column Description
Position The port location in node:slot:port format.
State The state of the port. See System and Component Status Icons .
Type Indicates whether the port is FC, iSCSI, RCIP, or RCFC.
Mode
Port firmware mode setting. Ports in Initiator mode are connected to
drive cages and ports in Target mode export to hosts. Suspended
mode is for target ports that have not yet been initialized by the system
(rare). Peer mode is for Ethernet ports.
Topology Type of connection (Private Loop, Public Loop, or Point-Point).
Rate
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4
Gbps). When there is no specified value, no connection exists.
Remote
Port WWN World Wide Name of the remote port.
Remote
Node WWN
World Wide Name of the remote node.
The following information is displayed in the lower pane:
Group Field Description
General
Location Port location.
Port WWN Port World Wide Name.
Node WWN Node World Wide Name.
Type Indicates whether the port is FC, iSCSI, RCIP, or RCFC.
Rate
Rate that data can be transferred over the port (1 Gbps,
2 Gbps or 4 Gbps). When there is no specified value,
no connection exists.
Connected
Device Type Type of device that the port is connected to. Free, Disk,
Host, or InServ.
Connected
Device
Name of device that the port is connected to, e.g. host1,
cage0.