HP 3PAR Operating System Software - Manual (Page 134)

3PAR InForm Management Console 4.1.0 User’s Guide
134 320-200231 Rev A
Port WWN Port World Wide Name.
Node WWN Node World Wide Name.
Type Indicates whether the port is FC, iSCSI, RCIP, or RCFC.
Rate
Rate that data can be transferred over the port (1 Gbps,
2 Gbps or 4 Gbps). When there is no specified value,
no connection exists.
Connected
Device Type
Type of device that the port is connected to. Free, Disk,
Host, or InServ.
Connected
Device Name of device that the port is connected to, e.g. host1,
cage0.
Mode
Port firmware mode setting. Ports in Initiator mode are
connected to drive cages and ports in Target mode
export to hosts. Suspended mode is for target ports
that have not yet been initialized by the system (rare).
Peer mode is for Ethernet ports.
State Current state of the port.
Resources
Total Data
Throughput
The throughput in KIB/sec.
Settings
Connection
Mode
The type of port connection.
Connection
Type
Connection type or port connection setting (Loop,
Point, or Loop-point). When the port is set to Loop-
point, both loop and point-to-point connections are
enabled.
Configured
Rate
Data transfer rate setting (for example,
1 Gbps). Auto indicates that the system automatically
selects the rate.
Max Rate Maximum rate of connection from the port.
Class 2
Indicates whether Fibre Channel service Class 2 is
Disabled, Ack 1 or Ack 0.
VCN
For fabric attached ports, indicates the VLUN change
notification setting. When set to Enabled, notices are
generated and sent to the fabric controller. When set to
Disabled, no notification is sent.