HP 3PAR Operating System Software User Manual
Page 281

3PAR InForm Management Console 4.1.0 User’s Guide
320-200231 Rev A
281
Editing Virtual Volumes (Fully
Provisioned from Physical Disks)
To edit a virtual volume, access the Edit Virtual Volume wizard.
1.
Access
the Virtual Volumes tab.
2. Right-click the volume you wish to edit.
3. In the menu that appears, click Edit.
The Edit Virtual Volume wizard appears.
Step 1. General
1. In the General group box:
a. Name - Enter a new name for the volume.
b. Comments - Enter any notes about the volume.
2. In the User Space group box:
a. Size - Enter the size of the volume. Change the Size list value to MiB or TiB as
applicable. The default is GiB.
Note: Minimum permitted volume size is 256MiB, maximum is 16TiB.
b. If the volume is Fully Provisioned from PDs:
i.
Device Type - Select FC for Fibre Channel drives, NL for Nearline drives, or
SSD for Solid State drives.
ii.
Device Speed - Select the appropriate speed or
Note: The Device Speed number does not represent a rotational
speed for the drives without spinning media (SSD). It is meant as a
rough estimation of the performance difference between the drive and
the other drives in the system. For FC and NL drives, the number
corresponds to both a performance measure and actual rotational speed.
For an SSD drive, the number is to be treated as relative performance
benchmark that takes into account in I/O per second, bandwidth, and
the access time.
iii.
RAID Type - Select the appropriate RAID type for the volume.
iv.
Set Size - Select the appropriate set size.