HP 3PAR Operating System Software - Manual (Page 155)

3PAR InForm Management Console 4.1.0 User’s Guide
320-200231 Rev A 155
Max Speed Maximum speed allowed by the SFP.
Qualified Displays whether the SFP has been qualified by 3PAR.
TX Disable Displays whether the transmit laser is disabled.
TX Fault Displays whether the transmit laser has a problem.
RX Loss
Displays whether the receive end of the SFP is experiencing a loss of
signal from the host or drive cage.
RX Power
Low
Displays whether the SFP receive power is low.
DDM Support
Displays whether the SFP is DDM-capable (Digital Diagnostic
Monitoring).
The lower pane provides the following information:
Group Field Description
General
Position Position of the port in which the SFP is installed.
State Current condition of the SFP.
Manufacturer
Manufacturer of the SFP.
Part Number Part number of the SFP.
Serial Number Serial number of the SFP.
Revision SFP's revision level.
Max Speed Maximum speed allowed by the SFP.
Qualified
Displays whether the SFP has been tested and if the SFP
is supported.