HP 3PAR Operating System Software - Manual (Page 350)

3PAR InForm Management Console 4.1.0 User’s Guide
350 320-200231 Rev A
the iSCSI port. The default setting is 1500. When supported by the
network, an MTU value of 9000 should be used.
Rate
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4
Gbps). When there is no specified value, no connection exists.
The following information is displayed in the lower pane:
Group Field Description
General
Location Port location.
Type Indicates whether the port is FC, iSCSI, RCIP, or RCFC.
Rate
Rate that data can be transferred over the port (1 Gbps, 2
Gbps or 4 Gbps). When there is no specified value, no
connection exists.
Connected
Device Type
Type of device that the port is connected to. Free, Disk,
Host, or InServ.
Connected
Device Name of device that the port is connected to, e.g. host1,
cage0.
Mode
Port firmware mode setting. Ports in Initiator mode are
connected to drive cages and ports in Target mode export
to hosts. Suspended mode is for target ports that have
not yet been initialized by the system (rare). Peer mode is
for Ethernet ports.
State Current state of the port.
IP
Settings
MAC
The Media Access Control address for the Ethernet
interface.
IP Address IP address of the RCIP port.
Gateway
The address of a local IP router on the same network as the
InServ, used to forward traffic to destinations beyond the
local network.
Subnet Mask Netmask address for the RCIP interface.