HP 3PAR Operating System Software - Manual (Page 164)

3PAR InForm Management Console 4.1.0 User’s Guide
164 320-200231 Rev A
Clearing Port Parameters
Note: This operation can only be performed on Remote Copy over Fibre
Channel, Remote Copy over IP, and iSCSI ports.
To clear a port's parameters:
1. Access the ports Summary tab.
2. Right-click the port to be cleared and then click Clear in the menu that appears.
The Clear Port Configuration dialog box appears.
3. Click Yes.
See also:
Viewing Port Summary Information
Resetting a Port
Note: This operation cannot be performed on Remote Copy over IP (RCIP)
ports.
To reset a port:
1. Access the ports Summary tab.
2. Right-click the port you wish to reset and then click Reset in the menu that appears.
The Reset Port dialog box appears.
3. (Optional) Select Reload Firmware if you wish to reload the port firmware upon reset.
4. Click Yes.
See also:
Viewing Port Summary Information