HP Matrix Operating Environment Software User Manual

Page 39

Select the box to present the volume. Clear the box to save the settings but not present the
volume at this time.

To change the LUN number, click on the LUN field and enter the correct value.

Select the appropriate mode (for example HPUX or Linux) from the list in the Host Mode field.

IMPORTANT:

The host mode list is populated from the modes selected in the array Properties,

under the Capabilities tab. To add other host mode options for the storage volume, modify
the capabilities of the array. See

To modify information in the Presented to Initiators table:
a.

Highlight an initiator in the table to select it.

To change the port type, select the correct value from the list in the Port Type field.

Although the software enables you to change the port type, it is unlikely to be required.

To change the port ID, enter the correct value into the Port ID field.

Use the port ID that you set in your array management software.

To remove an initiator, click Remove.

To modify information in the Presented by Targets table:
a.

Highlight a target in the table to select it.

NOTE:

An initiator and target must be on the same SAN.

Select or clear the box as needed to enable or disable the connection through the specified
port.

Click OK to save the modifications and exit the window.

Managing volume properties