KROHNE ALTOSONIC V EN - Manual (Page 73)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 73 of 106
6.11 Batch stop
After starting a batch, this batch can be stopped manually in the Batch Control window by F8, or by
Modbus command if enabled
Note that depending on security level it is only possible to stop a batch if flow is at zero conditions
Stopping a batch holds the following automatic actions:
- Saving of all parameters possible (in values) on ticket in a “batch stop” file that is secured by a
CRC-checksum.
- Make and save ticket according to the “layout ticket” file that is secured by a CRC-checksum
- If saving of the ticket failed a message will appear on screen and on the ticket.
- The ticket will be send to the printer after saving the ticket
In the picture above the batch is ended and is just started to print.
Batch status : END PRINT
Printer status : BUSY