KROHNE ALTOSONIC V EN - Manual (Page 13)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 13 of 106
3.2 Reading initialisation files on input range
Each parameter is checked for its input range.
1. If a parameter is out of range, the software switches to fail-mode.
(Only breakable by pin code 1357)
2. In fail mode a system set-up Error Code is given.
The parameter and its input range are printed on screen. If the Modbus communication is active
the set-up Error Code is also available on this output.
3. If there are no problems at start-up, the software checks whether the CRC-checked data files
correspond with the backup file BACK0300.bin.
This backup file also has a CRC-checksum. Only when the data files do not correspond or the
backup checksum gives an error, a new backup file and checksum are made.
3.3 Batch commands for configuration change and program start up
The following batch commands can be used in DOS mode:
No Name
Description
1 MEAS Start measure program to measure flow
2 AD Start calibrate-verify AD card IO (AD-812)
3 FR Start calibrate-verify Frequency card IO (MP103)
4 CLNT Edit parameters on IO, Spans etc
5 COMS Edit communication setup (Modbus, Batchprinter etc)
6 SYST Edit the system file (syst0300.ufs)
7 TICK Edit ticket (BOL) layout file
8 HSET Edit parameters on hardware settings of the UFP
9 SECU Secure all (configuration, programs, operating system)
10 BACKALL Make a backup to an empty floppy of flow configuration and OS
11 BACKFLOW Make a backup to an empty floppy of flow configuration only
12 BACKOS Make a backup to an empty floppy of Operating System OS only
13 BACKZIP Make a backup to empty floppy (zipped)
14 FLOW Edit the flow calibration file
15 REYN Edit the reynolds calibration file
16 SWRL Edit the swirl calibration file
Note that these files are custody transfer configurations and a password is required to enable the
changes for the measurement program.