KROHNE ALTOSONIC V EN - Manual (Page 35)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 35 of 106
4.8.4 Controls menu: F5 Density cell window
When a density cell is used to measure the density for Standard Volume calculation then the hardware
configuration must be made in the initialisation files HSET0300.ufp and CLNT0300.dat.
The calibration data for that particular cell can be set in the window below.
Description of the controls in this window:
Function keys do the controls of this window, therefore it is only possible to go back to the Main
window.
F1 : Go back to Main window
F2 (or ) : Set a parameter or disable/enable value change
F3 (or ) : Scroll up with red cursor. Or if value change is enabled (F2) increase value
F4 (or ) : Scroll down with red cursor. Or if value change is enabled (F2), decrease
value
F5 (or ) : If value change is enabled (F2) increase step value of change (F3, F4)
F6 (or ) : If value change is enabled (F2) decrease step value of change(F3, F4)
F7 (or ) : Increase the exponential value, when value change is enabled (F2)
F8 (or ) : Decrease the exponential value, when value change is enabled (F2)
F9 (or ) : Scroll the data set, possible to scroll between:
SOLARTRON 1
SOLARTRON 2
SARASOTA 1
SARASOTA 2
F10(or ) : Save configuration