KROHNE ALTOSONIC V EN - Manual (Page 65)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 65 of 106
6.3.1 Special characters for printer control:
Special characters for printer control start with a 3.
The so called escape codes for printer control can be inserted into the Ticket Layout
Examples:
~3007@ Printer sounds a bel
~3012@ Formfeed
~3027@~3067@~3000@~30xx@ Set page length in inch in ~30xx@: xx=1…22
~3027@~3067@~3000@~3xxx@ Set page length in lines in ~3xxx@: xx=1…127
~3027@~3087@~3049@ Select double sized characters
~3027@~3087@~3048@ Cancel double sized characters
~3027@~3071@ Select double strike printing
~3027@~3072@ Cancel double strike printing
~3027@~3052@ Select italic characters
~3027@~3053@ Cancel italic characters
~3027@~3054@ Cancel italic characters
~3027@~3057@ Enable paper out sensor
~3027@~3056@ Disable paper out sensor
6.4 Initial batch set-up
The initial batch set-up is by initialisation file CLNT0300.dat file under section 12:
\
•
There are 4 modes for Batch configuration:
BATCHING
ON
Start stop batch
permission Confirmation asked
on batch settings API settings during
batch possible
0 Batch mode disabled ------- ------
1 Only at zero flow
conditions
Yes No
2 At all flowing conditions Yes No
12
Only in use when a Epson Serial Printer according DIN66258 standard
is connected.
Note that in the HSET0300.UFP file (for hardware setup) the following data
must be set:
-1.4 Location_stat must be enabled (saving of status)
-1.8 Location_tic must be a disk with enough storage capacity
12.1 BATCHING_ON c=#2
//0=Internal batching disabled
//Manual batching modes:
//1=Enable Batching (start stop at zero flow)
//2=Enable Batching (start stop at all flows)
//Continuous piipe line modes
//3=Enable Batching: (Automatic)
//4=Enable Batching: (No Reset,possibly forced reset)
//If enabled then automatic initialize printer
12.2 Max_tickets c=#100
//Maximum number of last tickets saved 10..100000
//depending on disk space (see Location_tic above)
12.3 Hour_start c=#10
//Start hour 0..23 for continous pipe line ticket
12.4 Hour_interval c=#1 //Interval hour 1..24 for continous pipe line ticket
//0=No tickets automatically, only on demand
12.5 Modbus_control c=#1 //0=No Control batching through modbus
//1=Control batching through modbus
//2=as 0 with no printer alarm on printer failure
//3=as 1 with no printer alarm on printer failure