KROHNE ALTOSONIC V EN - Manual (Page 34)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 34 of 106
The OVERRIDE_CODE (9.14) makes it possible on first occurrence of active alarm to have:
•
(0) No override value, measurement value is used for calculations
•
(1) Use the default static override value OVERRIDE (9.13) .
•
(2) Use the batch average value of the parameter as calculated up to first occurrence of active
alarm
Description of the controls in this window:
The red arrow ► is the scrollable cursor position
Function keys do the controls of this window, therefore it is only possible to go back to the Main
window.
F1 : Go back to Main window
F2 (or ) : Set a parameter or disable/enable value change
F3 (or ) : Scroll up with red cursor ► . Or if value change is enabled (F2) increase value
F4 (or ) : Scroll down with red cursor ► . Or if value change is enabled (F2), decrease
value
F5 (or ) : If value change is enabled (F2) increase step value of change (F3, F4)
F6 (or ) : If value change is enabled (F2) decrease step value of change (F3,F4)
F7 (or ) : Set as manual override or measured input
F10 (or ) : Save configuration