KROHNE ALTOSONIC V EN - Manual (Page 21)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 21 of 106
A : 27 Calibration AD card File corrupt Install backup
A : 28 Calibration data Densito
Cells
File corrupt Automatic install of default values
Set the correct values on-line
A : 29 Batch ticket currently
saved A Requested batch ticket not available for
printing A ticket by that name was not
saved or had a previous save
error
A : 30 Batch ticket CRC error in a Batch ticket A ticket was not saved correctly
or was changed manually
W: 31 Read batch ticket
previously saved
A Requested batch ticket not available for
printing
A ticket by that name was not
saved or had a previous save
error
W : 32 Batch ticket close file Error in closing a ticket file Ticket file not closed , probably
because it could not be opened
See for the communication runtime errors also the ALTOSONIC V ModBus Manual.
Err no. In function Problem Consequence
W: 33 Modbus master Poll block not send due to transmit error
W: 34 Modbus master Poll block response time-out occurred
W: 35 Modbus master Invalid Slave ID in response
W: 36 Modbus master Invalid function in response
W: 37 Modbus master Response not correct
W: 38 Modbus master Error handling function 1,2
W: 39 Modbus master Error handling function 3,4
W: 40 Modbus master Error handling function 5
W: 41 Modbus master Error handling function 6
W: 42 Modbus master Error handling function 15
W: 43 Modbus master Error handling function 16
W: 44 Modbus master Exception received
W: 45 Modbus master Error unpacking Boolean data
W: 46 Modbus master Error unpacking integer data
W: 47 Modbus master Error unpacking long integer data
W: 48 Modbus master Error unpacking float data
W: 49 Modbus master Error unpacking double data
W: 50 Modbus master/slave Error incorrect message length
W: 51 Modbus master/slave Invalid CRC or LRC received
W: 52 Modbus master/slave Error receive buffer saturated
W: 53 Modbus master/slave UART error ( parity, framing, overrun )
W: 54 Modbus master/slave Transmit buffer not empty for new
transmission
W: 55 Modbus slave Unsupported function requested
W: 56 Modbus slave Unsupported register(s) requested
W: 57 Modbus slave Requested data Level and function
mismatch
W: 58 Modbus slave Too many data point (registers) requested
W: 59 Modbus slave Error unpacking received data
W: 60 Modbus slave Broadcast not allowed
Note: Occurred and disappeared alarms and warnings can be reset in the Control menu: F7 RES-
ERR. It is also possible to reset by digital input signal or Modbus Boolean.