KROHNE ALTOSONIC V EN - Manual (Page 7)

ALTOSONIC V
Operating Manual rev02 E 7.30850.34.00 Page 7 of 106
2 SYSTEM CONFIGURATION
2.1 Hardware configuration
The flow chart below includes all hardware specifications of the ALTOSONIC V regarding the flow
measurement.
Ultrasonic
Flow Sensor
(primary)
5 Ultrasonic
Flow
Converters Temperature
Proces
Temperature
Body
Temperature
Proving
(Ext flow)
Temperature
densitometer
Pressure
Proces
Density
standard
Density
densitometer
Viscosity
External
Pressure
Proving
(Ext flow)
Pressure
Densitometer
Secundairy
Input signals
External Flow
(Puls rate)
Configuration
Data files
UFS-V UFC-V UFP-V
Online files
Online status files
RS485/422 card
2 com ports
program:
measure
calibrate AD /FR
MP103 card
4 dig inputs
4 dig outputs
1 frequency outp
1 current output
2 frequency inp
1 pulscounter
Processor Card
AD Card
(16 analog inputs
2 analog outputs
All secundairy input signals can be read as
Modbus inputs from a host (except External flow puls rate)
Density densitometer signal can be connected from Solartron/Sarasota
Frequency signals. All Densities can be configured as normal frequency spans
Serial Batch Printer
according DIN66258
Modbus Master/Slave
to host system
Rs232/422/485
2 Current outputs*****
2 frequency outputs*****
1current output*****
4 digital outputs
OUTPUTS
***** Possible parameters on outputs:
Flow proces
Flow standard
Flow mass
Density Proces
Density standard
Velocity of sound
Volume correction factor
Viscosity
Temperature Proces
Pressure Proces
From this point on, in this manual the following abbreviations will be used
UFS-V : Ultrasonic Flow Sensor (primary flow-meter body)
UFC-V : Ultrasonic Flow Converter (5 converters)
UFP-V : Ultrasonic Flow Processor
UFP-Program : Software program running on the UFP-V for measuring the flow.