GW Instek GSP-730 User Manual - Manual (Page 61)

BASIC OPERATION
59
frequency column of the desired point.
Cursor
4. Enter the new frequency and amplitude of the
point using the keypad and the unit keys.
5. Repeat steps 3-5 for the remaining points (A
maximum of ten points).
6. To delete the selected point, press Delete [F3].
7. To delete all the points, press Delete All… [F4].
 The points will revert to their default frequency and
amplitude values.
8. To delete a point from the editing table, press
Delete.
 The whole points, including the frequency value and
the amplitude are removed. This command reduces
the number of points used in the limit line.
9. Press Undelete[F5] the restore the last point that
was deleted.
Pass/Fail Testing
Description The Pass/Fail testing uses the limit lines as
boundaries. When the input signal escapes the
boundary of the limit lines, then the test is
judged as a FAIL, if the signal stays within the
boundary, the test is judged as a PASS.