GW Instek GSP-730 User Manual - Manual (Page 22)

GSP-730 User Manual
20
5. Reboot the system when the update procedure
has finished by cycling the power button.
6. Check the software version again to confirm
the update procedure.
Note
The upgrade process may take a few minutes.
USB Driver Installation
Description If the type B USB port on the rear panel is to be
used for remote control, then the USB driver
must be installed. The USB driver is located in
the CD that accompanied this manual.
Driver installation 1. Ensure the GSP-730 is turned on.
2. Connect the USB cable from the PC
to the rear panel USB B port.
3. Windows will automatically detect the GSP-730
as a new device.
4. Follow the instructions to locate the GSP-730
driver on the accompanying CD and install the
driver.
5. To see if the driver has been successfully
installed, you can check to see if the GSP-730 is
recognized by the Windows Device Manager
when the GSP-730 in connected to the PC.
In Windows XP go to: Start>Control
Panel>Device Manager.