GW Instek GSP-730 User Manual - Manual (Page 55)

BASIC OPERATION
53
Operation:
Setting up the
adjacent
channel(s) 1. Press ADJCH Setup…[F3] to setup the adjacent
channels:
Adj CH BW 1[F1] Sets the bandwidth of
the 1
st adjacent channel.
Adj CH Offs 1[F2] Sets the channel offset of
the 1
st adjacent channel.
Adj CH BW 2[F3] Sets the bandwidth of
the 2
nd adjacent channel.
Adj CH Offs 2[F4] Sets the channel offset of
the 2
nd adjacent channel.
Note The adjacent channel bandwidth and space
settings are shown in the setup area at the
bottom of the screen, not on the soft-key icons.
Adj CH1 settings
Adj CH2 settings
Move Channels
Up/Down 1. Press the
Meas
again or press Return[F6]
repeatedly to return to the start of the Measure
menu tree.
2. Press CH Up[F5] to go to the next main
channel.
3. Press CH Down[F6] to go to the previous main
channel.
Note
The channel space (Main CH Space) setting
determines where the next main channel is
located.