GW Instek GSP-730 User Manual - Manual (Page 23)

GETTING STARTED
21
The GSP-730 should be shown under the
Ports (COM & LPT) node:
Note
If the USB driver installation fails, you can try to
manually install the driver.
You can tell that the driver hasn’t been installed if
you see the AT91USBSerial icon in the ports node.
Right clicking this icon will allow you to manually
install the GSP-730.ini driver.
Restoring Default Settings
Description The factory default settings can be easily
restored using the Preset key on the front
panel. The default settings cannot be changed.
See page 105 for a list of the factory default
settings.
Steps 1. Press
Preset
.
 The spectrum analyzer will load the default factory
settings.