Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) - Manual (Page 96)

76 Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
53-1002923-01
Adding target tape LUNs for encryption
2
NOTE
The controller LUN (LUN 0) must be added to the container as clear text in order for the host to see
the LUNs in the container.
For more detailed information on creating a CryptoTarget container, refer to the chapter describing
storage arrays in this administrator’s guide.
Adding target tape LUNs for encryption
You can configure a Crypto LUN by adding the LUN to the CryptoTarget container and enabling the
encryption property on the Crypto LUN. You must add LUNs manually. After you add the LUNs, you
must specify the encryption settings.
When configuring a LUN with multiple paths, the same LUN policies must be configured on all
paths to the LUN. If there are multiple paths to the same physical LUNs, then the LUNs are added
to multiple target containers (one target per storage device port).
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 1 on page 14.)
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar.
NOTE
You can also select a group, switch, or engine from the Encryption Center Devices table, then
click the Targets icon.
The Encryption Targets dialog box displays. (Refer to Figure 50 .) Initially, the table is empty. You
must add LUNs manually.
FIGURE 50 Encryption Targets dialog box
3. Select a target tape storage device from the Encryption Targets table, then click LUNs.
The Encryption Target Tape LUNs dialog box displays. (Refer to Figure 51 .)