Setting disk lun re-key all – Brocade Fabric OS Encryption Administrator’s Guide Supporting HP Secure Key Manager (SKM) and HP Enterprise Secure Key Manager (ESKM) Environments (Supporting Fabric OS v7.2.0) User Manual
Page 123
Fabric OS Encryption Administrator’s Guide (SKM/ESKM)
103
53-1002923-01
Rekeying all disk LUNs manually
2
The following conditions must be satisfied for the manual rekey operation to run successfully:
•
The node on which you perform the manual rekey operation must be a member of an
encryption group, and that encryption group must have a key vault configured.
•
The node must be running Fabric OS 7.0.0 or later.
•
The encryption group must be in the converged state.
•
The target container that hosts the LUN must be online.
In addition to providing the ability to launch manual rekey operations, Brocade Network Advisor
also enables you to monitor their progress.
Setting disk LUN Re-key All
To rekey all disk LUNs on an encryption node, complete these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to
2. Select the switch on which to perform a manual re-key from the Encryption Center Devices
table, then select Switch > Re-Key All from the menu task bar. (Refer to
.)
FIGURE 71
Selecting the Re-Key All operation
A warning displays, requesting confirmation to proceed with the rekey operation.
3. Click Yes.
Rekeying operations begin on up to 10 LUNs. If more than 10 LUNs are configured on the
switch, the remaining rekey operations are held in the pending state.
4. Open the Encryption Target Disk LUNs dialog box to see LUNs being rekeyed and LUNs
pending.
a. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to
b. Select the encryption switch from the Encryption Center Devices table, then select Targets
from the menu task bar.
The Encryption Targets dialog box displays. (Refer to
.)
5. Select a disk LUN device from the table, then click LUNs.
The Encryption Targets Disk LUNs dialog box displays. (Refer to
.) The dialog box
lists the status of the rekey operation.